Labe II-2004®
Products – Bridge drains Vlček-KOGA – Labe®II-2014
Labe® II-2014
Bridge drain with transverse rectification, 500 × 300 mm mesh on a hinge, with the possibility of being placed against the curb and rectification using screws.
Used:
Trench drain for concrete bridges
Load:
D400
Dimension:
500x300mm
Standard:
ČSN EN 124
Material:
Ductile cast iron
Surface treatment:
Bituminous coating
• possibility of installation directly at the curb – drainage axis 150 mm from the curb!!!
• new design of the inlet grate for D400 load with narrowed ribs
• protrusions on the surface of the grate improve hydraulic properties
• inlet surface of the grate: 588 cm²
• connection of the grate to the frame using a hinge, locking with a latch or screws without mechanical parts
• anti-noise seal stored in the frame grate
• the pot is equipped with drainage grooves for surface drainage of the insulation
• the skids in the pot allow transverse rectification
• rectification using screws or leveling frames and rectification pads
• the position in the transverse direction is defined by the formwork strips
• plate flange: slope 5° (8.5%), width 80 mm
• equipped with a dirt trap
• 13 drain variants as standard
• possibility of atypical design according to the project
